Drilling in Two Steps

This is an alternate technique to drilling with the 4.0 mm/4.5 mm Drill Bit in distal locking procedures. It is used only when there is insufficient space (less than 47 cm) between the receiver of the image intensifier and the bone, and a Radiolucent Drive is not available. The technique entails drilling in two steps: first with the 4.5 mm Drill Bit, and then with the 3.2 mm Drill Bit.

The following procedure replaces step 5 for the distal locking technique with the Distal Aiming Device section of this guide which begins here.



Next Page

UNS Index