Removing the Threaded Conical Bolt
Click on image for enlarged view
If the nail will not be locked proximally, remove the Insertion Handle
assembly. Use the pin wrench to loosen the Locking Nut one-half turn.
While holding the Insertion Handle firmly, remove the conical bolt
with the Combination Wrench or the Cannulated Socket Wrench.
Note: These instructions must befollowed to prevent cross-threading
of the conical bolt in the nail. See Special Techniques section of this guide for
more information.
If the nail will be locked, the Insertion Handle, Threaded Conical Bolt
and Locking Nut remain on the nail. The Insertion Handle must be
oriented medially to place the proximal locking bolts, and should be
reoriented to that position if necessary.
Next Page
UNS Index