Locking Distally, contd
Drill
Click on image for enlarged view
Align Drill Bit
Tilt the drive until the drill bit
is in line with the beam and
appears centered in the outer
ring. The drill bit will virtually
fill the locking hole image.
Hold the drill firmly in this
position and drill through
both cortices.
Important: Drill Bit Selection
- Use the 3.2 mm Radiolucent Drill Bit for 8 mm and 9 mm nails.
- Use the 4.0 mm Radiolucent Drill Bit for 10 mm - 13 mm nails.
Next Page
TTN Index