Instruments
       305.25            Graphic case
       310.19            Drill bit, 2.0 mm dia. (100/7S mm)*, for quick coupling,
                         2 ea.
       310.31            Drill bit, 3.2 mm dia. (145/120 mm), for quick coupling,
                         2 ea.
       31O.44            Drill bit, 4.5 mm dia. (145/120 mm), for quick coupling,
                         2 ea.
       3ll.44            T-handle, for 311.46
       3ll.46            Tap for 4.5 mm screws, 2 ea.
       312.32            **Insert drill sleeve, 4.5/3.2 mm
       312.45            **Tap sleeve, 4.5 mm
       314.12            **Hexagonal screwdriver, for 4.5/6.5 mm screws
       314.15            Hexagonal screwdriver shaft, for 4.5/6.5 min screws, for
                         quick coupling
       319.05            **Depth gauge, 4.5/6.5 mm
       319.97            Screw forceps, self-holding
       322.43            DCP drill guide, 4.5 mm (neutral and load), 60 mm
       338.00            DHS/DCS guide pin, 2.5 mm dia., 230 mm length, 10 ea.
       338.01            DHS angle guide, 1351
       338.02            DHS angle guide, 1401
       338.03            DHS angle guide, 1451
       338.04            DHS angle guide, 1500
       338.05            DHS/DCS direct measuring device
       338.06            DHS/DCS wrench, for DHS/DCS lag screws
       338.08            DHS/DCS T-handle, with coupling, for DHS angle guides
                         and DHS/DCS tap
       338.13            DHS triple reamer, complete, for standard barrel DHS
                         plates
       338.14            DHS/DCS impactor
       338.17            DHS/DCS tap, 12.5 mm dia.
       338.18            Centering sleeve, for DHS/DCS tap, short
       338.19            Centering sleeve, for DHS/DCS wrench, long
       338.20            Coupling screw, for DHS/DCS lag screw insertion
       338.21            DHS/DCS gihde shaft, for use with 338.20
       338.22            Coupling screw, for DHS/DCS lag screw removal, large
       338.44            DHS reaming head, for short barrel DHS plates

Implants
       4.5 mm Cortex Screws:
       214.28&30         28 & 30 mm lengths, 3 ea.
       214.32            32 mm length, 8 ea.
       214.34-40***      34-40 mm lengths, 12 ea.
       214.42-46***      42 46 mm lengths, 8 ea.
       214.48&50         48 & 50 mm lengths, 4 ea.
       214.52&54         52 & 54 mm lengths, 3 ea.

        * (total length/effective length)
       ** Available while supply lasts.  To be replaced with upgraded instruments.
       *** 2 mm length increments

       The DHS/Basic Set is also available with drill bits for Jacobs chuck
       [No. 105.37J].